I got my GSI Hae Tea Kettle in today that I ordered from REI a few days ago. I got this kettle to use with my Original White Box stove for a light-weight set up for 2. This is my first kettle, so I was excited to get it in, since I have heard so much about kettles.
A few things about the kettle. It is made of GSI’s Halulite, which is a hard-anodized alloy that distributes heat evenly which promotes a faster, more efficient burn. Also, GSI claims that their Halulite is scratch and abrasion resistant. The kettle features a single uncovered pour spout on one side, and a ld that is able to be completely removed. The lid has a single silicone-coated loop atop it which allows te lid to be removed without burning my fingers in the process. It also features a single handle which is also silicone-coated and has a single nook in which the kettle can hang evenly from. The handle will swivel side to side to allow for easy storage.
My thoughts so far. The kettle is listed at 5.5 oz, however on my scales it shows 5.9 oz. The lid seats great in the kettle, however it does not fit tightly, so it will simply fall off once the kettle is turned over so far. This means for storage I will have to create a way to keep it held together, especially if I store my stove and other stuff inside it. This could also be a problem when pouring the last bit of water out of the kettle, unless I just completely remove the lid before pouring. And I have noticed that the lid can be a bit difficult to remove when the handle is in the upright position. The handles arch inwards and the lid hits the handles while trying to lift the lid up.
Don’t get me wrong. These things can be remedied, and probably fairly easily. While I cannot do anything about the weight (which is the only truly disappointing thing about the kettle so far) I can make slight modifications to the other matters. So, overall, so far I really do like the kettle, and am planning on using it on a 3-day trip with my son and I on Memorial Day weekend. I have faith in the little kettle.
I did a practice burn with the kettle once I got it today. I did use the Original White Box stove, and the heat reflector and windscreen that came with the stove. I also used 1 oz of HEET (yellow bottle). I filled the kettle with 3 cups of cold tap water. I lite the stove and waited for it to blossom, and then gave it another 15 – 20 seconds to be sure it was warmed up. From the time I put the kettle on till the time the water achieved a full rolling boil was exactly 10 minutes, and just at the 11 1/2 minute mark the stove burnt out.
After this, later on I decided to do one more run at it. I used the same type and amount of fuel in the same stove, with the same set-up and the same amount of water in the same kettle. However, what I did this time was open the windscreen as far as I could while still being attached with a paper clip at the ends. The first time it was nearly all the way opened, but not quite all the way. The first time the distance between the kettle and the windscreen varied between 1/4″ – 1/2″ (this is because the windscreen is not perfectly shaped in a circle – it’s aluminum so I do the best I can!). The second time the variations were between 1/2″ – 3/4″. The burn times were quite a bit faster, this time beginning a boil at ~ 6 minutes and 25 seconds, and maintaining a full rolling boil at 7 minutes, but also its burn out time was quicker, at ~ 9 minutes and 35 seconds.
So, this is what I know so far on the Kettle. I definitely plan on using it much more, and will post a full report on it when I do so.